Eight tips for installing the socket and switch properly and correctly
1.Before installation, the dirt and rubbish in the junction box should be cleaned, and also should observe the box to see if there is deformation, cracking, water stains, etc.
2.The switch and socket should be installed properly, tight and flush with the wall face.
3.The surfaced type switches and sockets should be mounted properly, and the necessary waterproof covers should be installed upon the switches and sockets of the restroom.
4.For safety concern, please do not install socket and switch at the head of the bed or on the table.
5.In places such as nurseries and kindergartens where the children can easily reach the socket, the socket installation height should not be less than 1.8 meters.
6.All wires should be fully in contact with the terminals after installation. There will be accidents with defect of rusted and oxidized wire.
7.Do not adding multiple strands of wires in the same terminal, otherwise it may cause overload and even fire.
8.Remove the frame before the install, after the complete, put back the frame. And better wrap the frame with plastic bags to avoid any contamination or damage caused by decoration.